{"id":47694,"date":"2021-03-16T16:28:00","date_gmt":"2021-03-16T21:28:00","guid":{"rendered":"https:\/\/www.peinfo.com\/?post_type=product&p=47694"},"modified":"2021-05-26T13:39:57","modified_gmt":"2021-05-26T18:39:57","slug":"mmv138crh","status":"publish","type":"product","link":"https:\/\/www.peinfo.com\/product\/mmv138crh\/","title":{"rendered":"MMV138CRH"},"content":{"rendered":"\n
\n
\n
\n
\n

<<< Back to all models in this series<\/a><\/p>\n\n\n\n\n\n

<\/div>\n\n\n\n
\n

Notice for CRH models:<\/strong><\/h3>\n\n\n\n

All MMV-CRH\u2122 (Conical Rotor Hoist) models are specialty VFDs<\/em><\/strong> – built from the ground up specifically for hoists with a conical-rotor motor <\/a>and encoder feedback<\/strong>. <\/p>\n\n\n\n

Use the drive listed on this page ONLY IF you have this type of application (contact PE\u00ae if you are unsure). <\/p>\n<\/div>\n\n\n\n

<\/p>\n<\/div><\/div>\n\n\n\n

\n\n\n\n\n

Add one of the resistors listed below<\/strong> to your quote request unless one of the exact models shown is already installed in your application.<\/p>\n\n\n\n

\n

Important note regarding Encoders and Pulse Count selection:<\/strong> Many conical-rotor motors used in a hoist application have a BUILT-IN (low ppr count) encoder. In this case, you do not need to select an encoder option below (you should also leave the Encoder Pulse Count option as “Standard”).<\/p>\n\n\n\n

However, if your motor DOES NOT have an existing encoder, you will need to supply and mount one on the motor. If you will be adding one of the PE\u00ae encoder options shown here, make sure you also select the “P2” model option for the MMV-CRH. Contact PE\u00ae<\/sup><\/strong><\/a> if you are unsure.<\/strong> <\/p>\n<\/div>\n\n\n\n

Select Product Options<\/h2>\n\n\n<\/div><\/div>\n<\/div><\/div><\/div>\n\n\n\n
<\/div>\n\n\n\n