P.C.22 – Set EXACT motor nameplate FLA (U22)

Meaning: Programming Code 22 – FLA input needed at parameter U22. Also known as: pc22, pc 22.

Note: You will only see this code on Ver 2.2 or 4.2 drives (or higher). If the display on your drive alternates between “P.C. 22” and “rOFF” or “cOFF”, this means the drive’s U22 parameter has not yet been set (Motor Overload Setting). This is typically the case when you are installing a new drive, or after certain changes have been made within the “U parameter” group. The U parameters are where the drive stores motor nameplate data and basic brake settings. These parameters should be set to match the braking operation type and motor specifications used in your application. If the P.C.22 message is flashing on the display, the drive will not accept control input, and will not send power to the motor or brake output until parameter U22 is properly set.

Method for Entering Full Load Amps into the U22 Parameter:

1.
Confirm that the VFD is Version 2.2.
2.
At the “cOFF” readout (or “rOFF” readout), hold the “Scroll” button in until “U” appears. Then release.
3.
Display will show “0”.
4.
Use the “Increase” button to increase the value on the display to “369”. If you go past this number you can press the decrease button to adjust.
5.
Tap on the “Scroll” button (do not hold in), until “U22” is displayed.
6.
Use the “Increase” button to change display to the Total Full Load Amps of your motor(s).
7.
Hold in the “Scroll” button until “_OFF” is displayed. Then release.
8.
The VFD is now ready to run, and the “P.C.22” message will no longer be displayed.

The video below demonstrates the programming procedure required to properly set the U22 parameter value. After this procedure is performed, the P.C.22 code will no longer display.

About Power Electronics® International, Inc.®

As a world-class manufacturer of Micro-Speed® variable frequency drives and Smooth-Move® reduced torque control units, PE® equipment is world-renowned for high reliability and quality. Multi-Vector® drives also make PE® the world leader in heavy-duty closed-loop quality hoist speed control. With over a quarter of a million crane/hoist motions utilizing Power Electronics® International, Inc.® equipment, you can be assured if it's PE® then it's the best! PE® is also a UL and cUL approved manufacturer of quality control panels and automation systems.

Contact us today!
Email: sales@peinfo.com
Phone: (847) 428-9494

All PE® products are MADE IN THE U.S.A.

Join the Power eLetter!
Sign up to receive our timely product and company updates.

© 2025 Power Electronics® International, Inc.® — 561-8 Plate Drive, East Dundee, IL 60118-2467 USA